MINS-BARO only three digits

Post Reply
eiketre
Posts: 60
Joined: 31 Oct 2020, 12:36
Location: Norway

MINS-BARO only three digits

Post by eiketre »

Hi

EFIS ->MINS-> BARO
For T/O it is normal to set this to Minimum Flap Retraction Altitude (MFRA). This is often a higher value than 999.
It can only show 3 digits on my system. Can you check if it can show four digits?

Regards
eiketre
Posts: 60
Joined: 31 Oct 2020, 12:36
Location: Norway

Re: MINS-BARO only three digits

Post by eiketre »

This was solved with 1.01b6 :-)
Post Reply

Return to “ProSimB38M - Technical support - software related”