.CDU FAIL
-
pelsrijcken
- Posts: 482
- Joined: 03 Jan 2015, 13:35
- Location: Den Hoorn, Texel; The Netherlands
CDU FAIL
In ProSim V2.31 I lost connection to my hardware CDU CPT side, it keeps showing the 'FAIL' message. Checked all IP-addresses, they're OK. The Prosim module works OK. Had this a few times before, but I forgot how to get it working again, all I know it was a simple solution. Promise to write down the golden tip this time .
.Regards, Koosch.
-
pelsrijcken
- Posts: 482
- Joined: 03 Jan 2015, 13:35
- Location: Den Hoorn, Texel; The Netherlands
Re: CDU FAIL SOLVED
Solved the problem: proved to be a conflict between different versions.
Regards, Koosch.